Error Code: E2 / F2 E2 Whirlpool

Whirlpool Dishwasher Error Code E2 (F2 E2): How to Fix It

A step-by-step guide to fixing the E2 / F2 E2 (User Interface) error on Whirlpool dishwashers.

Verification Pending

Checking community feedback...

Did this work?

The Logic Verdict

My Take: The video author notes: “If you get this E2 F2 or F2 E2 error code… I ordered this part [User Interface]… and that worked for me.” Based on this, I recommend inspecting the User Interface Board first.

What It Means

The E2 code (usually displayed as F2 E2) indicates a User Interface (UI) Failure. The main control board has lost communication with the keypad/display panel on the door.

Common Causes

  1. Faulty User Interface Board: The electronic board inside the door panel has failed.
  2. Loose Connection: The wire harness connecting the UI to the main board is loose or corroded.
  3. Moisture Damage: Steam from the vent has damaged the UI board (check the vent gasket).

Step-by-Step Fix

  1. Reset Power:
    • Turn off the breaker for 1 minute. If the code returns, the UI board likely needs replacement.
  2. Access the UI Board:
    • Safety: Turn off the breaker.
    • Remove Door Panel: Open the door and remove the T-15 Torx screws around the inner door liner.
    • Separate Panels: Carefully separate the outer door panel from the inner liner.
    • Remove Control Housing: Locate the plastic housing at the top of the door containing the buttons/display.
  3. Replace the UI Board:
    • Unscrew the housing (often 3/16” screws) and release the retaining clips.
    • Disconnect the wire harness.
    • Remove the old UI board and install the new one.
  4. Check Vent Gasket:
    • Inspect the rubber gasket around the steam vent. If it’s loose or missing, steam can escape and damage the new board. Glue it back in place if needed.
  5. Reassemble:
    • Put everything back together and turn the power back on.

Resources

The Logic Verdict

My Take: The video author notes: “Thought I’d make this short video since I couldn’t find anything else explaining how to fix this issue. Hopefully this works for you if you’re having the same problem.” Based on this, I recommend inspecting the Control Board first.

What It Means

The E2 code indicates an issue with…

Common Causes

  1. Temporary Sensor Glitch
  2. Wiring Connection Issue
  3. Component Failure (Rare)

Step-by-Step Fix

  1. Safety First: Unplug the appliance before performing any inspection.
  2. Access the Control Board: Consult the video to locate the Control Board.
  3. Inspect/Test: Check the Control Board for visible damage or test it with a multimeter if shown.
  4. Replace if Needed: If the part is faulty, replace it with a compatible new one.

Resources

Don't Panic When Spills Happen.

Get our printable Emergency Stain Chart for your laundry room. Know exactly how to treat wine, oil, blood, and ink instantly.

We respect your inbox. No spam, just solutions.